Loading Laundry; Adding Detergent And Care Product; Starting The Programme; Adding Laundry - Bosch WAU28PH0SG User Manual And Installation Instructiions

Table of Contents

Advertisement

en operation
Note: To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 26
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 30
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.7 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 31
32
Press
.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
13.9 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 26
Remove the laundry.
3.
→ "Unloading the laundry",
Page 33
programme.

Advertisement

Table of Contents
loading

Table of Contents