Maintenance - Husqvarna 435e II Operator's Manual

To cut trees and branches that are in tension
1. Figure out which side of the tree or branch that is in
tension.
2. Figure out where the point of maximum tension is.
(Fig. 80)
3. Examine which is the safest procedure to release the
tension.
Note:
In some situations the only safe procedure
is to use a winch and not your product.
4. Keep a position where the tree or branch can not hit
you when the tension is released. (Fig. 81)
5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension. (Fig. 82)
WARNING:
through a tree or branch that is in
tension.
WARNING:
you cut a tree that is in tension. There is
a risk that the tree moves quickly before
or after you cut it. Serious injury can
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
a check of the throttle trigger and
throttle trigger lockout on page 23 .
Make sure that there is no damage
on the vibration damping units.
1270 - 005 - 21.06.2021
Do not cut straight
Be very careful when

Maintenance

Read and understand the
Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
27 .
Do a check of the starter, starter rope
To do
and return spring.
Lubricate the needle bearing. Refer
To lubricate the needle bearing on
to
page 26 .
occur if you are in an incorrect position
or if you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in. (Fig. 83)
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released. (Fig. 84)
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION:
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of the air intake on the starter. This
increases the engine temperature.
2. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space. (Fig. 85)
CAUTION:
cover if the temperature increases above
-5°C/23°F. Risk of too high engine
temperature and damage to the engine.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 22 .
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug. Refer to
a check of the spark plug on page
25 .
Snow and cold weather can
Remove the winter
To do
21