Maintenance - Husqvarna T542i XP Operator's Manual

• Do a check of the harness, belt and ropes at a
regular interval.
• If you must climb with the product, attach the product
to the rear connection point on the harness. The
rear connection point keeps the product clear from
climbing lines and makes sure that the weight has
central support down your spine.
WARNING:
chain brake when you lower the product
onto its strop.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
WARNING:
you do maintenance.

Maintenance

Clean the external parts of the product.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Clean the chain brake and make sure that it operates safely. Make sure that the
chain catcher is not damaged. Replace it if necessary.
Turn the guide bar for more equal wear. Make sure that the lubrication hole in
the guide bar is not clogged. Clean the bar groove.
Make sure that the cutter and cutter guard have no cracks and that they are not
damaged. Replace the cutter or cutter guard if they have cracks or if they have
been exposed to impact.
Make sure that the guide bar and saw chain have sufficient oil.
2120 - 004 - 08.09.2023
You must engage the
Maintenance
Read and understand the
Remove the battery before
To remove a trapped product
1. Stop the product.
2. Attach the product safely to the tree inboard, against
the trunk side, of the cut or a different tool line.
3. Carefully pull the saw away from the kerf while you
lift the branch as necessary.
WARNING:
product free. Risk of serious injury.
4. If it is necessary, use a hand saw or a second
chainsaw to release the product. Cut the branch at
a minimum of 30 cm/12 in from the caught product.
Make the cut on the outer end from where the
product is caught.
The following is a list of the maintenance steps that you
must do on the product. Refer to
19 for more information.
Do not try to pull the
Maintenance on page
Before
Weekly Monthly
use
X
X
X
X
X
X
19