Rimage Prism Install Manual page 5

17. Roll up the ribbon leader so it is wrapped only once around the roller. Do not
go past the marking on the leader that states –
Take-up Core Stopping here
18. Install the cardboard Take-up Roller in the printer as shown. At this time, the
ribbon should be tight and there should be no creases in the ribbon.
19. Install the Take-up Roller in the printer and press down firmly until the Take-
up Roller snaps into place.
20. The "
STOP - Wind Leader Onto Take-up Core Stopping here
Ribbon Leader should not be rolled onto the take-up roller. The marking
should not be past the point shown in the above picture. If the marking is on
the roller, pull the Take-up Roller out and roll back the ribbon. Take up the
slack by rolling the supply roller back.
21. Press the Unit Attention button to close the drawer. The ribbon should be
pulled tight after it runs the ribbon validation process.
22. Install the top cover.
InstallingPrismRibbon.doc
STOP - Wind Leader Onto
.
5 of 5
" marking on the