Advertisement
Available languages
Available languages
6. Operation
Switch on the device using the On/off button
fan level 0 and the water fill level.
Select the fan speed using the fan button in the centre of the upper side.
Graphic displayed
The water level gauge indicates the tub fill level:
Graphic displayed
The air washer is switched off by pressing the On/off button
Regularly check the water level gauge during operation and refill the tub if necessary.
Note:
• The actual humidification output depends on the ambient conditions and the air contact with the
humidification discs. In principle, the lower the relative air humidity, the higher the humidification,
and the greater the damp contact surface with the air, the higher the humidification.
• The LCD illumination reduces 5 seconds after a button has been pressed. The reduced display
illumination enables the device to be operated in bedrooms.
• Use fan level 1 to operate the device during the night.
Usage with an external timer
Switch the device to the desired ventilation level and then disconnect the
plug (without turning the device off with the ON/OFF button). Connect the
timer between the plug and the socket and the air washer will turn on at the
desired time at the previously selected ventilation level.
Fan level
Level 0, standby – fan off
Level 1, low
Level 2, medium
Level 3, maximum
Fill level
approx. 4.3 l to 7.25 l
Approx. 2.5 l to 4.3 l
Approx. 0.5 l to 2.5 l
Residual water in tub.
The tank must be refilled.
Device automatically switches off after 6 hours.
The device has switched itself off due to safety reasons. Clean and refill the
device before next use.
in the centre of the upper cover. The display lights up, shows
on the upper side.
16
Advertisement
