Page 2
AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.
Page 3
NORTH AMERICAN REQUIREMENTS • This appliance must be installed in locations where it can be overseen by trained personnel. • For proper operation, this appliance must be installed where the temperature is between 41°F to 95°F (5°C to 35°C). • Appliance shall not be tilted more than 10° for safe operation. •...
Page 4
3. Slip bag under the chute. Rest the bag on the tray. 4. Press the start switch. 5. Flip the cleaning lever a few times as dispensing slows. 6. Remove the bag. The grinder will stop automatically. START 39956.0000 - G1 39957.0000 - G2 & G3...
Page 5
ELECTRICAL REQUIREMENTS CAUTION - The grinder must be disconnected from the power source until specified in Initial Setup. Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. 100V & 120V 230 VOLT Models CE Model NOTE : This electrical service consists of 2 current carrying conductors (L1 and Neutral) and a separate conductor for chassis ground.
Page 6
Reinstall rotor cup and grind selector dial plate to the burr housing. Refer to the “BURR ADJUSTMENT” section to adjust burrs. PREVENTIVE MAINTENANCE Bunn-O-Matic® Corporation recommends performing preventive maintenance at regular intervals. Maintenance must be performed by a qualified technician. For technical service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
Page 7
COFFEE GRINDING Turn the selector knob to align the arrow with the desired grind. Raise the top lid and add the whole bean coffee. Close the top lid. Locate the back of a bag behind the dispense chute or insert the brew cup. (The grinder will not operate unless the bag/brew cup sensor is activated) Allow the bag to rest on the screen beneath the chute.