Husqvarna AUTOMOWER 430X Operator's Manual page 59

10.1 Supplier's Declaration of
Conformity
Issuer: Husqvarna AB, Drottninggatan 2, S-561
82 Huskvarna, Sweden
www.husqvarnagroup.com.
Responsible party: Husqvarna Professional
Products, Inc. 9335 Harris Corners Parkway
Suite 500 Charlotte, NC 28269 United States
U.S. Contact information: James McNew,
Manager Product Compliance, Telephone: +1
704 597 5000.
10.2 Compliance requirements
FCC ID: XPY1CGM5NNN (Automower
module).
FCC ID: ZASHQ-BLE-1A and FCC ID ZASHQ-
®
BLE-1B (Bluetooth module).
The Bluetooth module is located on the HMI-
board (PCBA) in the upper chassis. It must only
be accessed by an authorized service technician.
The device complies with part 15 of the FCC
Rules. Operation is subjected to the following 2
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: To comply with RF
exposure requirements, please
maintain a separation distance of at
least 20 cm/ 7 inches from any part of
the product.
Models with a hatch: The supplied label shall be
attached to the product according to figure below.
1201 - 001 - 05.06.2019
10 Applicable to US/CA market
Models without a hatch: The supplied label shall
be attached to the product according to figure
®
Connect
below
Note: Changes or modifications made to this
equipment not expressly approved by Husqvarna
may void the FCC authorization to operate this
equipment.
Note: This device complies with Part 15 of the
FCC Rules [and with Industry Canada licence-
exempt RSS standard(s)]. Operation is subject to
the following two conditions: this device may not
cause harmful interference, and this device must
accept any interference received, including
interference that may cause undesired operation.
Husqvarna Automower Connect
®
This device contains the module
FCC ID: XPY1CGM5NNN
Husqvarna Automower Connect
®
This device contains the module
FCC ID: XPY1CGM5NNN
Applicable to US/CA market -
59