Husqvarna AUTOMOWER 430X Operator's Manual page 27

3. Read the messages and read the
Troubleshooting to get information and
recommendations to correct the faults.
3.10.6 Weather timer
Weather timer allows the product to
The
automatically adjust its mowing time based on
how fast the grass grows.
Weather timer is activated, the product
When the
needs time to decide the optimal mowing time for
the work area in question. For this reason it can
take a couple of days before mowing is optimized
Weather timer .
for the
The product cannot operate longer than the timer
settings. It is therefore recommended to only
deselect the times when the product must not
operate. All other time should be made available
Weather timer .
for the
Weather timer is activated, it is very
When the
important to regularly check that the blade disc is
clean and that the blades are in good condition.
Any grass twisted around the blade disc shaft, or
blunt blades, can affect the
Note: If the mowing results are not satisfying, the
cutting time can be adjusted to mow for a longer
(High) or for a shorter time (Low) .
time
3.10.6.1 To set the Weather timer
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
timer > Use .
3. Push the OK button to select
4. Use the arrow buttons to set the cutting
time. You can select between
High .
3.10.7 Installation
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
1201 - 001 - 05.06.2019
Weather timer .
Weather
Weather timer .
Low, Mid,
3.10.7.1 Lawn coverage
GPS Assisted Navigation helps the product to
select the most optimal operation. Refer to
disable and enable the GPS function
®
(Automower 430X/450X) on page 27 . In more
complex gardens operation can be improved by
carrying out some of the manual settings in the
Lawn coverage menu.
Lawn coverage function is used to guide the
The
product to remote parts of the work area. If the
work area includes areas that are connected with
Lawn coverage function is
narrow passages, the
useful to be able to maintain a well-cut lawn in all
parts of the yard. The product begins to mow
Lawn coverage point. At all
when it reaches the
other times, the product leaves the charging
station in the standard manner and starts to mow.
To disable and enable the GPS function
®
(Automower 430X/450X)
Disable the GPS Assisted Navigation to make
manual settings in Lawn Coverage .
Note: It is recommended to use GPS Assisted
Navigation.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn Coverage .
3. Push the OK button to disable or enable the
GPS Assisted Navigation.
To
Installation
Installation - 27