Husqvarna AUTOMOWER 430X Operator's Manual page 5

29. Couplers for the loop wire
30. Loop wire for boundary loop and guide wire
2
3
31. Stakes
32. Connectors for the loop wire
1.4 Symbols on the product
These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Operate the
disabling device before
working on or lifting the
machine.
The product can only start
when the correct PIN
code has been entered.
Switch off the product be-
fore carrying out any in-
spections and/or mainte-
nance.
WARNING: Keep a safe
distance from the ma-
chine when operating.
Keep your hands and feet
away from the rotating
blades.
WARNING: Do not ride
on the machine. Never
put your hands or feet
close to or under the ma-
chine.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
1
Is a part of the Installation kit which is purchased separately.
2
See note 1
3
See note 1
4
See note 1
1201 - 001 - 05.06.2019
1
4
1.5 Symbols on the display
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 55 and on the
rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
guarantee no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.
The timer function controls when the
product cuts the lawn.
The cutting height function sets the
cutting height of the product.
The security function lets the operator
select between 3 security levels.
Introduction - 5