Husqvarna AUTOMOWER 430X Operator's Manual page 26

• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.4.1 To set the security level
Select 1 of 3 security levels for your product.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Security level .
3. Use the arrow buttons and the OK button to
select the level of security.
4. Push the OK button.
3.10.4.2 To change the PIN-code
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Security > Advanced > Change PIN-code .
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
3.10.4.3 To create a New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if two
adjacent installations have a very similar signal.
1. Place the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 24 .
26 - Installation
3. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > New loop signal .
4. Await confirmation that the loop signal has
been generated. This normally takes about
10 seconds.
3.10.4.4 To set duration of alarm and time lock
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Advanced > Duration .
3. Enter the time for the
the number buttons. You can select a
number between 1 to 10 minutes.
4. Use the arrow buttons to select
time lock .
5. Enter the time for the
with the number buttons. You can select a
Settings >
number between 1 to 100 days. The factory
setting is 30 days.
3.10.5 Messages
In this menu the previous fault and information
messages can be found. For some of the
messages, there are tips and advice to help to
rectify the fault. Refer to
Settings >
41 .
If the product is disrupted in any way, for
example it is trapped or the battery is low, a
message is saved relating to the disruption and
the time it happened.
If the same message is repeated several times,
this may indicate that an adjustment to the
installation or the product is required. Refer to
Installation on page 16 .
3.10.5.1 To read the messages
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Fault messages and Messages > Info
messages .
Security >
To get access to the menu
Security >
Duration of alarm with
Duration of
Duration of time lock
Troubleshooting on page
To get access to the menu
Messages
1201 - 001 - 05.06.2019