Husqvarna AUTOMOWER 430X Operator's Manual page 48

Message Cause
Weak signal
Weak GPS signal for Automower
Connect module
SIM card requires The SIM card must be unlocked.
PIN
SIM card locked
The SIM card must be replaced.
SIM card not found Automower
card to be inserted in the mower.
GeoFence prob-
The GeoFence is not work due to poor
lem
(or no) communication with the system.
6.4 LED indicator lamp on the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If any other color than green is visible, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Green solid light
Good signals
Green flashing
The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Red flashing light
Interruption in the charging station's an-
tenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
48 - Troubleshooting
®
®
Connect requires a SIM
ECO mode is
Action
Make sure that the product is not up-
side down. If the problem remains, the
message requires action by an author-
ized service technician.
Make sure the correct SIM PIN has
been entered into the mower's menu
(Network > SIM card). Contact your lo-
cal Husqvarna representative if this
message appears often.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
Action
No action required
No action required. For more informa-
ECO mode . Refer to ECO mode
tion on
on page 31 .
Check that the boundary wire connec-
tors are fitted properly to the charging
To install the boundary
station. Refer to
wire on page 21 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler.
Contact your local Husqvarna repre-
sentative.
Contact your local Husqvarna repre-
sentative.
1201 - 001 - 05.06.2019