3.3 Settings in Subrange tab
In the Subrange tab, the following parameters can be set:
Figure 21: Settings of the Subrange tab
Table 3-2: Setting in the Subrange tab
01.00
Frequency
Start and stop frequency for this subrange. The
stop frequency must always be higher than the
start frequency.
Properties
Subrange Name:
Individual name can be defined here for the
subrange or band
Enabled:
Detectors
If one or both detectors should be used for this
subrange. If only one detector is selected it will
be used for this subrange automatically.
Detector
Allows to check ClearWrite and / or Maxhold
Mode
Rohde & Schwarz EMI Automotive Band Evaluation with R&S©EMC32-K51 – 1SP07- 20
Checked: Measurement defined in this
subrange will be carried out during test
run,
Unchecked: Measurement defined in this
subrange will be skipped during test run
ClearWrite: New measurement value
overwrites the old one, and
MaxHold: New measurement value is
stored if it is higher than the old one
Configuration of Test Cases in the Editor