R&S EMC32 Application Note page 17

Table 3-1: Icons of the Test Setup tab
01.00
Transducer
SignalPath
Receiver
Rohde & Schwarz EMI Automotive Band Evaluation with R&S©EMC32-K51 – 1SP07- 17
Right click:
Available are all transducer and antenna devices
depending whether this is a conducted or
radiated measure.
Note: the antenna does not support polarization
settings.
Left click:
The properties editor of the transducer pops up,
the dedicated dialogs are shown in Figure 18
Right click:
The name of the SignalPath will be automatically
generated after choosing both a transducer and
a receiver by right-clicks of the mouse.
Alternatively an existing signal path may be
selected.Left click:
The properties editor of the SignalPath pops up
(Figure
19).
Receiver parameters can't be configured before
defining the other devices). After selecting the
receiver, the parameters (e.g. IF BW, step
size...) of the receiver can be set here by clicking
the mouse button on the receiver.Right click:
From the pop up list of receivers an appropriate
device is chosen.Left click:
The properties of the receiver has to be set as
shown in Figure 20.
This read only icon shows the Level Unit, the
unit of the measured signal. The setting is done
in Measurement Correction tab in Figure 18
Configuration of Test Cases in the Editor