Configuration Of An Emi Automotive Radiated Test Template; The Upper Part Of The Template Editor - R&S EMC32 Application Note

Configuration of EMI Automotive Band Evaluation Test

2.2.2 Configuration of an EMI Automotive radiated test template

Figure 12: The three parts of the Template editor
2.2.2.1

The upper part of the template editor

The upper part contains a tab structure in which the general settings, valid for the
whole frequency range, that means for all defined sub-ranges are done. This part
consists of two tabs; General Settings and Report.
Figure 13: General settings for all sub-ranges listed in the middle part
In the General Settings tab (Table 2-1) Receiver Check and Device Mode can be
defined. Never change the Device Mode in a given Template, otherwise all sub ranges
in the middle part of the template will be deleted. The template offers three device
modes but one of them, the "Single Measurement" mode is very specific, it is a
customer solution which description is not part of this application note.
Rohde & Schwarz EMI Automotive Band Evaluation with R&S©EMC32-K51 – 1SP07- 12
01.00