Unpacking - REVELL Ultima Gem User Manual

UNPACKING

To avoid injury, please use care during unpacking. Always
stand as straight as possible and use your leg muscles to lift a
REVEL ULTIMA GEM loudspeaker. Do not lift it while bend-
ing from the waist.
To unpack a REVEL ULTIMA GEM loudspeaker, perform the
following steps:
1. Place a REVEL ULTIMA GEM loudspeaker onto its side.
2. Open the bottom flaps. Stand the carton in the up position.
3. Lift the carton off the loudspeaker and set it aside, being careful
not to damage the contents (see Figure 3).
Left Pad
4. Remove the allen wrench and set it aside.
5. Remove the left and right pads and the protective cloth. Use
caution to avoid scraping the finish or pulling off the grille.
After unpacking the unit, carefully inspect it for possible damage
due to shipping. If you discover any damage, immediately contact
your Revel dealer for further assistance. When moving a REVEL
ULTIMA GEM loudspeaker (e.g., when experimenting with place-
ment), avoid touching the transducers.
Keep all packing materials for future shipping. In the unlikely
event a product will need repair, Revel will only accept a unit in its
original shipping carton. Using any other packing materials may
result in damage to the product and is not covered by the warranty.
See Obtaining Service on page 19 for additional details.
6 REVEL ULTIMA GEM
Owner's Manual
Allen Wrench
Warranty Card and
Owner's Manual
Right Pad
WARNING
Figure 3. A REVEL
ULTIMA GEM loudspeaker
with its inner packing materials.