Table of Contents
Advertisement
BEFORE USING THE GLASS CERAMIC HOB
• To make the most of your new appliance, please read the user
instructions carefully and keep them handy for future consultation.
INSTALLATION
Cooktop
• The cooktop must be set into a worktop between 20 mm and 50 mm
deep
• There must be nothing between the cooktop and the oven (cross
rails, brackets, etc.).
• The distance between the lower face of the glass ceramic hob and the
cupboard or separating panel must be at least 20 mm.
• If the cooktop is to be installed next to a column unit, leave a distance
of at least 100 mm from the edge of the cooktop to the side of the
column unit.
• Make an opening in the worktop, respecting the dimensions indicated in
the enclosed product description sheet.
• Apply the supplied gasket to the cooktop (unless it has already been fitted),
after having cleaned its surface.
Important
In order to prevent the electronic circuits from overheating, and therefore from
being damaged, we recommend the following:
• Do not install the cooktop near a dishwasher or washing machine,
so that the electronic circuits do not come into contact with steam
or moisture, which could damage them.
If an oven (from our range of ovens) is installed beneath the cooktop, make
sure that it is equipped with a cooling system.If the temperature of the
electronic circuits exceeds the maximum permitted temperature, the cooktop
will switch off automatically; in this case, wait for a few minutes until the internal
temperature of the electronic circuits reaches a tolerable level, at which point
it will be possible to switch the hob on again.
• Switch the hob off after use.
4
Rear wall
Front
min. 20 mm
min. 5 mm
1
2
3
Advertisement
Table of Contents
