Stamina 55-1530 Owner's Manual page 12

OPERATIONAL INSTRUCTIONS
HEEL HOLDER USE AND ADJUSTMENT
1. Place your feet on the FOOTREST(7) with your ankles between the
HEEL HOLDERS(13) and FOAM PADS(10).
2. The HEIGHT ADJUSTMENT BEAM(6) includes a lever to grip and
release your feet. Pull the lever toward you until your ankles are securely
held between the HEEL HOLDERS(13) and FOAM PADS(10).
3. To release your feet or relax the grip, pull the lever toward you slightly
and press the button on the end of the lever.
USING THE INVERSION TABLE
1. Check the decline angle before using the Inversion Stretch System. To increase the decline,
lengthen the straps. To decrease the decline, shorten the straps.
WARNING: DO NOT ALLOW table to invert past vertical. Table inverting past vertical may result in table
contacting frame, damage to table and serious injury to user due to fall hazard. Prior to each
use, make sure nylon and buckle straps are securely attached, as instructed in Steps 9 and
10. Adjust straps to desired angle of inversion, making sure that Main Frame does not strike
Front Frame at any time during use, as shown in illustration below.
Not Past Vertical
NOTE: There must
always be a gap
between the Main
Frame and the Front
Frame when in use.
12
Button
Past Vertical