Realvü Appearance Settings; Panoptix Transducer Installation Settings - Garmin GPSMAP 12x3 Owner's Manual

RealVü Appearance Settings
From a RealVü sonar view, select Options > Sonar Setup > Appearance.
Point Colors: Sets a different color palette for the sonar return points.
Bottom Colors: Sets the color scheme for the bottom.
Bottom Style: Sets the style for the bottom. When you are in deep water, you can select the Points option and
manually set the range to a shallower value.
Color Key: Shows a legend of the depths the colors represent.
On-screen Control: Shows or hides the on-screen buttons.

Panoptix Transducer Installation Settings

From a Panoptix sonar view, select Options > Sonar Setup > Installation.
Install Depth: Sets the depth below the water line where the Panoptix transducer is mounted. Entering the actual
depth at which the transducer is mounted results in a more accurate visual presentation of what is in the
water.
Bow Offset: Sets the distance between the bow and the forward view Panoptix transducer installation location.
This allows you to view the forward distance from the bow instead of the transducer location.
This applies to Panoptix transducers in the FrontVü, LiveVü Forward, and RealVü 3D Forward sonar views.
Beam Width: Sets the width of the down view Panoptix transducer beam. Narrow beam widths allow you to see
deeper and farther. Wider beam widths allow you to see more coverage area.
This applies to Panoptix transducers in the FrontVü, LiveVü Down, and LiveVü Forward sonar views.
Use AHRS: Enables the internal attitude heading and reference system (AHRS) sensors to detect the installation
angle of the Panoptix transducer automatically. When this setting is turned off, you can enter the specific
installation angle for the transducer using the Pitch Angle setting. Many forward view transducers are
installed at a 45-degree angle and down view transducers are installed at a zero-degree angle.
Flipped: Sets the orientation of the Panoptix sonar view when the down view transducer is installed with the
cables pointing toward the port side of the boat.
This applies to Panoptix transducers in the LiveVü Down, RealVü 3D Down, and RealVü 3D Historical sonar
views.
Calibrate Compass: Calibrates the internal compass in the Panoptix transducer
page 91).
This applies to Panoptix transducers with an internal compass, such as the PS21-TR transducer.
Orientation: Controls if the transducer is in down or forward installation mode. The Auto setting uses the AHRS
sensor to determine the orientation.
This applies to PS22 transducers.
Restore Sonar Defaults: Restores the sonar settings to the factory default values.
90
(Calibrating the Compass,
Sonar Fishfinder