Data Pages - Raymarine SmartPilot ST6001 Commissioning Manual

Chapter 3: Adjusting SmartPilot Settings

Data pages

SmartPilot controllers have 15 user-configurable pages. The following screens
allow you to modify the settings for the data pages. These define which SeaTalk/
NMEA data pages will be available during normal operation (see
Operating Guide
PAGE and the page number. After 1 second, the text changes to the title of the
data set for that page.
The default settings are:
Data Page
1
2
3
4
Remaining pages
It is good practice to keep the BTW and DTW pages for display. If your SmartPi-
Note:
lot receives a man overboard
distance to the
To change the data displayed on a data page:
1. Press disp to move to the appropriate data page setup screen.
2. Use the -1 and +1 keys or the rotary control to scroll forwards or back-
wards through the available data pages (see following table).
3. Then press disp to move to the next data page you want to change, or press
and hold standby for 2 seconds to save changes.
Available Data Pages
Speed Knots
Log
Trip
Average Speed, Knots
Wind Direction
Wind Speed
). Each data page setup screen initially shows the title DATA
Default Setting
XTE
(Cross Track Error)
BTW
DTW
RESPONSE
NOT USED (These pages are not displayed when you scroll
through the data pages during normal operation)
message, these data pages will show the bearing and
(MOB)
location.
MOB
(Bearing to Waypoint) - see Note below
(Distance to Waypoint) - see Note below
Displayed as
SPEED KTS
LOG
XXXX.X
TRIP
XXX.X
AV. SPD KTS
WIND PORT
e.g.
WIND KTS
43
SmartPilot