How To Set Up The Wiper; How To Set Up The Washer - Axis Q8685-E User Manual

AXIS Q8685-E PTZ Network Camera
About PTZ (Pan Tilt Zoom)
Note
Disabling PTZ controls will not affect preset positions. For example, if the tilt control is disabled, the product can still move to
preset positions that require a tilt movement.

How to set up the wiper

1. Go to PTZ > Advanced > Device.
2. To set the duration of the wiper sequence in seconds, enter a value for the Wiper dwell time.
Note
The set value applies only to the wiper sequence and has no effect on how long the wiper operates as part of the washer
sequence if optional washer is used.
3. Click Save.

How to set up the washer

Note
The washer is optional.
1. Go to Live View.
2. Click Set emulated joystick mode, see PTZ Controls on page 14.
3. Use the joystick to position the washer nozzle in the center of the live view image.
4. Go to PTZ > Advanced > Device.
5. Select Nozzle Position.
6. Go to System Options > Ports & Devices > I/O Ports.
7. Select Output from the I/O Port Type drop-down list for the I/O port used with the washer.
8. Go to PTZ > Advanced > Device.
9. To select the I/O port the washer is connected to, enter a value for the Washer pump pin.
10. To set the duration of the the washer sequence in seconds, enter a value for the Washer pump time. The wiper starts when
there is 5 seconds left of this time.
11. To set the duration of the wiper sequence in seconds, enter a value for the Washer wiper time.
12. Click Save.
The below table provides some examples of different washer-wiper sequence set-ups.
Time elapsed (seconds)
0
5
10
15
20
22
Washer pump time: 10 s
Washer wiper time: 10 s
Washer starts
Wiper starts
Washer stops
Wiper stops
—
—
37
Washer pump time: 20 s
Washer wiper time: 12 s
Washer starts
—
—
Wiper starts
Washer stops
Wiper stops