Table of Contents
Advertisement
Chapter 4: Setup
4. Press the
5. Repeat the procedure in steps 3 and 4 until all instruments in the
Note: If you have more than eight standard instruments, a second
group, operated by another Remote Keypad, must be created. The
identification code for additional Keypads and instruments would for
example, be B1 , B2 etc.
6. Assign a Remote Keypad to the required group as follows:
Group setup indications - allocating keypad
7. If you are creating more than one group, repeat the procedures
key to select another instrument and repeat the
procedure in step 3.
group have been identified.
(a) Use the
or
group.
(b) Press the
and
on the type of instruments you are grouping, the following
messages are displayed on the instruments with the same
group letter.
Typical ST80 digital
Typical ST60 digital
(c) At the Remote Keypad, press any one of the keys dedicated to
the standard instruments, to assign the Remote Keypad to the
selected instrument group.
described in steps 2 to 6.
key to select any instrument in the required
keys together for 1 second. Depending
Typical ST80 analogue
Typical ST60 analogue
15
ST60 Tridata
D2784-3
Advertisement
Table of Contents
