GreenWorks 21332 Owner's Manual page 17

OPERATION
CHARGER MAINTENANCE
• Keep the charger clean and clear of debris. Do not allow foreign material into the recessed
cavity or on the contacts. Wipe with a dry cloth. Do not use solvents, water, or place in wet
conditions.
• Always unplug the charger when there is no battery pack in it.
• The battery pack may be stored in the charger, however, it is recommended to disconnect
the charger from the power source. To ensure safety and reliability all repairs should be
• Check that the charger contacts have not been shorted by debris or foreign material.
CHARGER MOUNTING (See Figure 11)
• This charger can be installed hanging on a wall using two screws (not supplied)
• Locate the placement for the charger to be wall mounted.
• If fastening to wood studs use 2 wood screws.
• Drill two holes 2 3/8" (6 cm) on center ensuring they are level.
• If fastening to dry wall use wall anchors and screws to secure the charger to the wall.
Fig. 11
16