GreenWorks 21332 Owner's Manual page 11

ASSEMBLY INSTRUCTION
AUXILIARY HANDLE (
W A R N I N G
To avoid injury, adjust the auxiliary handle for optimum control and balance. Do not overreach
when operating grass trimmer/edger. Keep proper balance at all times for better control of the tool
in unexpected situations.
1
1. Position auxiliary handle onto the upper porti on of the trimmer shaft by sliding over shaft.
2. Once auxiliary handle is in the desired in use position tighten the knob until locked into position.
3. Auxiliary handle can be adjusted to suitable positon.
C ONNECTING UPPER/LOWER TRIMMER SHAFTS
With lower shaft pointing downward insert lower
clockwise to tighten.
ADJUST THE CUTTING WIDTH
The cutting blade can be rotated 180° for change the
cutting width from 10'' to 12''. see right picture.
NOTE:
Phillips screwdriver will be used. (not supplied)
CUTTIN G LINE (
See Figure 4.)
line needs replacing, insert a new spool.
To avoid injury, always remove the battery pack before installing the guard, changing a cutting
line, or making any adjustments.
To remove the spool:
1. Disconnect trimmer from the power supply.
2. Turn grass trimmer/edger over to access the spool.
3. Remove spool cover by pressing on two tabs parallel to each other on the side of the cover (2).
4. Remove the spool (1) from the spool housing (3).
REPLACEMENT SPOOL MODEL#29632
See Figure 3.)
3
2
shaft into upper shaft and turn shaft collar
10
12''
10''
Fig.3