Table of Contents
Advertisement
4.
Remove the Phillips M1.6 × 2.0 screw (4) that secures the touchpad to the computer. Note that this
screw requires a Phillips P0 screwdriver.
5.
Remove the touchpad from the computer (5).
To install the touchpad, reverse this procedure.
Top-cover camera
To remove the top-cover camera, use this procedure and illustration.
Table 5-5
Top-cover camera description and part number
Description
Top-cover camera
NOTE:
The top-cover camera cable is included in the Cable Kit, spare part number M03431-001. The
top-cover camera bracket is included in the Bracket Kit, spare part number M03436-001. The top-
cover camera thermal shield is included in the Plastics Kit, spare part number N39195-001.
Before removing the top-cover camera, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the top-cover camera:
1.
Remove the foil that covers the top-cover camera.
2.
Release the ZIF connector (1) the top-cover camera cable is connected to, and then disconnect the
cable from the top-cover camera board.
Preparation for disassembly on page
Bottom cover on page
Battery on page
35).
34).
Spare part number
N39206-001
34).
Top-cover camera
39
Advertisement
Table of Contents
