ICON Health & Fitness NTRW15122-INT.4 User Manual page 25

Note: For clarity, the console is not shown in the
drawing below.
Tighten the four
M6 x 16mm
Screws (96) in
the Rear Bracket
Mount (10) until
the up and down
movement no
longer feels loose.
Tilt the console
upward and down-
ward to access
the Screws. Then,
reattach the Upper
and Lower Console Covers (22, 23).
HOW TO ADJUST THE DRIVE BELT
If you feel the strap slip while you are rowing, even
when the resistance is adjusted to the highest level,
the drive belt may need to be adjusted. To adjust the
drive belt, first unplug the power adapter.
Next, see assembly step 8 on page 10. Remove
the Right and Left Neck Shields (77, 78) from the
rower.
Note: For clarity, the console is not shown in the
drawing below.
Remove the Row Bar (19) from the Row Bar
Hook (88).
19
88
86
96
7
10
96
76
87
75
79
80
Then, remove the Flywheel Cover (86), the Strap
Cover (87), the Front Cover (79), the Bottom Cover
(80), and the Right and Left Shields (75, 76) from the
rower. To locate the screws that attach each part,
see EXPLODED DRAWING A on page 30.
Make sure to note the location of each size of
screw used to attach these parts.
Note: You will need the help of a second person to
tip the rower to the side so that you can access the
Bottom Cover (80).
Locate the Drive
Belt (99) on the
right side of the
rower.
Next, loosen the
two M10 x 20mm
Screws (101).
Tighten the
M10 x 60mm
Screw (103) until
the Drive Belt
is tight. Then
tighten the two
M10 x 20mm
Screws.
When the Drive Belt (99) is tight, reattach the parts that
you removed and plug in the power adapter.
25
101
103
99