Chamberlain 87504-267 Manual page 24
Smart led garage door openers
Hide thumbs
Also See for 87504-267:
- Manual (180 pages) ,
- Owner's manual (56 pages) ,
- User manual (21 pages)
Advertisement
Available languages
Available languages
Control Panel
2 Wire the Control Panel to the Garage Door Opener
PRE-WIRED INSTALLATIONS: When wiring the control panel to the garage door opener make sure you use the
same wires that are connected to the control panel.
1.
Run the white and red/white wire from the control panel to the garage door opener. Attach the wire to the
wall and ceiling with staples (not applicable for gang box or pre-wired installations). Do not pierce the wire
with the staple as this may cause a short or an open circuit.
2.
Strip 7/16" (11 mm) of insulation from the end of the wire near the garage door opener.
3.
Connect the wire to the red and white terminals on the garage door opener. To insert or release wires from
the terminal, push in the tab with screwdriver tip.
Push bar
COMMAND LED
3 Attach the Warning Labels
1.
Attach the entrapment warning label on the wall near the control panel with tacks or staples.
2.
Attach the manual release/safety reverse test label in a visible location on the inside of the garage door.
24
Advertisement
Chapters
