Datavideo PTC-300 Instruction Manual page 54

Step 10. Please use the left arrow button and the right arrow button to select
the "Yes" button and then press the "ENTER" button again to save the setting.
Step 11. After the setting is saved, please press the "MENU" button to
exit to the previous menu and to exit the OSD menu of the HS-1300. The
"Standard" option setting for the HS-1300 is finished until this step.
Step 12. Please open the web UI of the PTC-300.
Step 13. Please click the "Video" option, and then please select "OSD" from
the "Video Format" drop-down menu.
Step 14. Please click the "Apply" button .
Step 15. Please click the "Reboot" button in the "System" option to reboot the
PTC-300.
Step 16. After the PTC-300 is rebooted, please use an SDI cable to connect
from the 3G-SDI interface which is located on the rear panel of the PTC-300 to
the SDI IN interface which is located on the rear panel of the HS-1300, or you
can use an HDMI cable to connect from the HDMI interface which is located on
the rear panel of the PTC-300 to the HDMI IN interface which is located on the
54