Approved Vent; Rear Vent Configurations; Top Vent Configurations; Termination - FireplaceXtrordinair 564 GSR2 25K CF Installation Manual

Finalizing the Installation

Approved Vent

Rear Vent Configurations


Horizontal Terminations: use 8" (203mm) diameter Dura-Vent Model Direct-Vent Pro*.

Vertical Terminations: use 8" (203mm) diameter Dura-Vent Model Direct-Vent Pro* for the initial
horizontal run and 90° upward elbow. Then attach the 8" (203mm) to 6-5/8" (168mm) reducer (Travis
part # 98900165) to the elbow. Use 6-5/8" (168mm) diameter for the remaining vent.

Top Vent Configurations


Horizontal Terminations: use 8" (203mm) diameter Dura-Vent Model Direct-Vent Pro*.

Vertical Terminations: Use 6-5/8" (168mm) diameter Dura-Vent Direct-Vent Pro*. Attach the 8"
(203mm) to 6-5/8" (168mm) reducer (Travis part # 98900165) to the fireplace.
* Other vent may be approved with this fireplace. Check with the vent manufacturer for details.

Termination


Always use the high-wind cap (part # 58DVA-HC, 58DVA-VCH, 46DVA-VCH).

Vent Installation


Installation instructions for Dura-Vent may be found at www.duravent.com

Slide the vent sections together and turn 1/4 turn until the sections lock in
place.

Screws are not required to secure the vent. However, three screws may be
used to secure vent sections together if desired.

High temperature sealant is recommended at the appliance starter section
connection (use high-temperature silicone or Mill-Pac®).

If disassembly is required, at time of re-assembly check to see if the vent
creates a tight fit. If it does not, apply high temperature sealant to the joints
of the affected sections.

Horizontal sections require a 1/4" (6mm) rise every 12" (305mm) of travel

Horizontal sections require non-combustible support every three feet (e.g.: plumbing tape)
© Travis Industries
(for qualified installers only)
6-5/8" (168mm) Diameter Vent
Reducer - # 98900165
1/8/2020 - 1505
23
564 GSR2 25K CF