Self-Cleaning Surface; Removing And Fitting The Appliance Door; Cleaning The Door Panels - NEFF B12S32 3GB Series Instruction Manual

Keeping the appliance clean
To avoid getting the cooking compartment dirty,
clean the cooking compartment after each use, as dirt will
■
bake on the next time it is heated up, and this can only be
removed with difficulty
always remove flecks of limescale, grease, starch and
■
albumin (e.g. egg white) immediately
use CircoTherm® whenever possible. This operating
3
■
mode creates less dirt
Use the universal pan to bake very moist cakes
■
use suitable ovenware when roasting (e.g. roasting dish) or a
■
roasting sheet (see section: Accessories)

Self-cleaning surface

The back wall of the cooking compartment is coated with self-
cleaning enamel. This coating absorbs and disintegrates
splashes from baking and roasting while the oven is in
operation.
Large splashes only disappear after the oven has been used
several times.
Discolouration on the rear wall does not affect the self-cleaning
function.
Caution!
Damage to surfaces on self-cleaning areas due to applying
oven cleaner.Never clean the self-cleaning surfaces with oven
cleaner.
If oven cleaner accidentally gets onto self-cleaning surfaces,
remove it immediately with a sponge and plenty of water.
Caution!
Damage to surfaces on self-cleaning areas due to the use of
abrasive and acidic cleaning agents and aids.
Do not use cleaning agents containing abrasive substances or
acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
18
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A)
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
Fitting the appliance door
Insert the hinges in the left and right-hand holders (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.

Cleaning the door panels

To facilitate cleaning, you can remove the inner door panels
from the appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.