Table of Contents
Advertisement
Legacy USB Support [Enabled]
[Disabled]
The USB devices can be used only for the BIOS setup program. It cannot
be recognized in boot devices list.
[Enabled]
Enables the support for USB devices on legacy operating systems (OS).
[Auto]
Allows the system to detect the presence of USB devices at startup. If
detected, the USB controller legacy mode is enabled. If no USB device is
detected, the legacy USB support is disabled.
XHCI Hand-off [Enabled]
Allows you to enable or disable workaround for OS(s) without XHCI hand-off support.
Configuration options: [Disabled] [Enabled]
USB Mass Storage Driver Support [Enabled]
Allows you to enable or disable USB Mass Storage driver support.
Configuration options: [Disabled] [Enabled]
Port 60/64 Emulation [Enabled]
Allows you to enable or disable Port 60/64 Emulation.
Configuration options: [Disabled] [Enabled]
USB transfer time-out [20 sec]
Allows you to set the USB transfer time-out value.
Configuration options: [1 sec] [5 sec] [1 sec] [20 sec]
Device reset time-out [20 sec]
Allows you to set the device reset time-out value.
Configuration options: [10 sec] 20 sec] [30 sec] [40 sec]
Device power-up delay [Auto]
Allows you to set the maximum time the device takes before the device reports itself to the
host controller properly.
Configuration options: [Auto] [Manual]
The following item appears only when you set Console Redirection to [Manual].
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds. Use the <+> or <-> to adjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CD-ROM]
P11C-C/4L
4-21
Advertisement
Table of Contents
