Table of Contents
Advertisement
STATE: Indicates video loss changes.
OK: Video loss is recovered.
LS: Video level is below normal and in sync.
VL: Video level is below normal and out of
sync.
HL: Video level is above normal and out of
sync.
TYPE: Place where the video loss occurs.
S: Video crosspoint input (Not supported)
C: Camera control input
DATE/TIME: Date and time when the video loss state
changes.
4. To display the next page, press the + button.
To display the previous page, press the – button.
Note:
• To display the first page of table, press the + but-
ton while holding down the SHIFT button.
• To display the last page of table, press the – button
while holding down the SHIFT button.
5. To exit the VIDEO LOSS HISTORY table, perform
either of the following.
• Select a camera. (Refer to p. 39 Camera
Selection.)
• Press the MON(ESC) button.
• Press the EXIT button.
Note:
• This feature is available in only WJ-SX650 or
WJ-SX850 because of OSD limitation.
■ Area Change
Note:
• The following function is available only if the
assignments of monitor surveillance areas has
been established through admin console. (Refer to
the Admin Console User's Guide.)
1. Display "Area No" menu. (Refer to Step 1 and 2 of
p. 53 To Recall Menu Functions.)
Area No:1
Set
2. Select an area number by pressing the numeric
buttons.
Note:
• If you have selected an area not assigned through
the admin console, operations will become
unavailable. In this case, log out, and then log into
the system again. (Refer to p. 38 Login and
Logout.)
3. Press the F1 button. The area will be changed.
■ Operator ID
You can check your operator ID as follows.
Display "Ope ID" menu. (Refer to Step 1 and 2 of p. 53
To Recall Menu Functions.)
Your operator ID will be displayed on the LCD.
■ Controller ID
You can check your System Controller ID as follows.
Display "Cnt ID" menu. (Refer to Step 1 and 2 of p. 53
To Recall Menu Functions.)
Your System Controller ID will be displayed on the
LCD.
■ System Version
You can check the system version of CPU as follows.
Display "Ver" menu. (Refer to Step 1 and 2 of p. 53 To
Recall Menu Functions.)
012
The system version of CPU will be displayed on the
LCD.
Area No:9
Set
Ope ID :100
Cnt ID :001
Ver: 5.0.0.0
012
013
014
015
59
Advertisement
Table of Contents
