■ To Operate Alarm-related
Camera (ACK)
You can operate the camera associated with the alarm
action as follows:
1. Perform Step 1 and 2 of Alarm Selection.
2. Enter a desired alarm action number by pressing
the numeric buttons.
Note:
• If you skip this step, Alarm Action #0 will be speci-
fied.
MON 9
0123
Active
3. Press the ACK button.
"Ack:n" will appear on the LCD.
MON Alarm00001
0123 Ack:9
4. Control the cameras with the system controller.
(Refer to p. 41 Camera Site Accessories Control.)
Note:
• To select another alarm, press the ALARM/ALM
SUSPEND button. The ACK status will be can-
celed (cancelled). Then, enter the alarm action
number by pressing the numeric buttons, and
press the ACK button again.
50
■ To Cancel Alarms
• To reset all the alarms at a time, press the ALM
CAM
00512
• After the alarm is deactivated, "Armed" or
CAM
00512
1. Perform Step 1 to 2 of p. 49 Alarm Selection.
2. Press the ALM RESET/ALM ALL RESET button to
reset the alarm. "Reset" will be displayed on the
LCD.
MON Alarm00001 CAM
0123
Reset
Note:
RESET/ALM ALL RESET button while holding
down the SHIFT button.
MON Alarm00001 CAM
0123 ALL Reset 00512
"Cleared" will be displayed on the LCD.
MON Alarm00001 CAM
0123
Armed
MON Alarm00001 CAM
0123
Cleared
00512
00512
00512