Table of Contents
Advertisement
2. To move the camera to the position to be preset,
move the 3D joystick and press the lens control
buttons.
3. To select the desired preset position number, press
the numeric buttons.
MON 15
0123 Unit:01
Note:
• When you have selected a wrong number, press
the CLEAR button to clear the numeric input.
4. Press the PRESET/PGM PRESET button while
holding down the SHIFT button. The preset posi-
tion will be saved.
MON PrgPre:15
0123 Unit:01
Note:
• If the entered position number has stored the pre-
vious preset position, it will be overwritten by the
new one.
● Call Preset Position
1. Select the desired monitor and camera. (Refer to
p. 39 Monitor Selection and Camera Selection.)
2. To select the desired preset position number, press
the numeric buttons.
MON 15
0123 Unit:01
Note:
• When you have selected a wrong number, press
the CLEAR button to clear the numeric input.
42
CAM
00512
• To call preset positions, you must set preset posi-
■ Wiper Control
The following procedure is available when a selected
camera (housing) is equipped with a wiper.
CAM
00512
• When the WIPER button is released, the LCD dis-
CAM
00512
3. Press the PRESET/PGM PRESET button. The
camera will move to the preset position, and the
image of selected preset position will be displayed
on the active monitor.
MON Preset:15
0123 Unit:01
Note:
tion numbers for the camera in advance.
1. Select the desired monitor and camera. (Refer to
p. 39 Monitor Selection and Camera Selection.)
2. Keep pressing the WIPER button.
The wiper will be activated while this button is
being pressed.
MON Wiper On
0123 Unit:01
Note:
play will become as follows.
MON Wiper Off
0123 Unit:01
CAM
00512
CAM
00512
CAM
00512
Advertisement
Table of Contents
