Remove The Battery Pack; Operation; Cold Weather Operation; Blue Led Light - GreenWorks Pro SNC407 Operator's Manual

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door (11).
2. Align the ribs on the battery pack (33) with the grooves in
the battery compartment.
3. Push the battery pack (33) into the battery compartment
until the battery pack (33) locks into place.
4. When you hear a click, the battery pack (33) is installed.
5. Close the battery door (11).
7.7

REMOVE THE BATTERY PACK

1. Open the battery door (11).
2. Push and hold the battery release button.
3. Remove the battery pack (33) from the machine.
8

OPERATION

WARNING
Wear eye protection during operation.
8.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
WARNING
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use of the
machine.
If the machine does not start:
• remove the battery pack from the machine,
• charge the battery pack to 15 minutes in warm area, or
when the charging light turns green.
• Install the battery pack back in the unit.
English
8.2

BLUE LED LIGHT

34
1. LED light flashes blue if the battery voltage is low. Place
the battery in a room temperature area and charge until
the green charger light is flashing green.
2. Blue LED light (34) is always on if the battery
temperature is low. Bring the Battery and Charger in to a
warm area. Place the Battery in the charger and allow for
the battery to reach room temperature or when the light
on the charger is flashing Green. Once charger is flashing
green, take the battery and place it in the unit to begin
work.
8.3

START THE MACHINE

2
14
9
9
EN