Quick Setup - Adey MagnaClean Professional3 Sense Installation And Servicing

Quick Set-up
Step 1.
Power on your filter.
Insert Battery
When batteries are fitted for the first time or
replaced.
Step 2.
Connect your Filter to the Wi-Fi network (Note: Use only in conjunction with the ADEY Sense App).
Initiate Connection Mode
Press and hold Check Button for 6 seconds,
this will initiate "Connection Mode". Connection
Mode will last for 2 minutes.
Step 3.
Install filter onto heating system.
Step 4.
Reset the filter after fitting to the heating system (and after every service).
Filter Reset
Press and hold Reset Button for 6 seconds, will
reset unit to a clean filter status.
LED OPERATION
All (GREEN) LEDs will illuminate for 2 seconds
then go off.
LED OPERATION
All (GREEN) LEDs will flash twice as soon as
Connection Mode is initiated.
1.
2.
LED OPERATION
All (GREEN) LEDs will illuminate.
LEDs will begin counting down while "Filter
Reset" is applied (right to left).
1.
2.
3.
4.
Flash Twice
9