Table of Contents
Advertisement
en Installation instructions
An all-pole isolating switch must be integrated into the
permanent electrical installation according to the install-
ation regulations.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
Connect the hob in accordance with the connection
2.
diagram.
The yellow/green wire for the safety earth terminal
must be 10 mm longer on the appliance side than
the other wires.
See the rating plate for the voltage.
Connection 3N~ / 2N~ / 1N~: Use a H05VV-F
mains power cable or one with a higher rating.
24.6 Installing the appliance
Remove the transport locks on the right and left and
1.
then dispose of them.
The appliance must be transported by two people
2.
using the carry handles on the right and left, while
securing the front of the appliance with one hand.
Place the appliance in the unit and fold the carry
3.
handles down.
Push the appliance in fully.
4.
42
Do not kink or trap the connection cable, or route it
over sharp edges.
Centre the appliance.
5.
There must be an air gap of at least 5 mm between
the appliance and adjacent unit fronts.
Use a spirit level to adjust the appliance so that it is
6.
perfectly level.
Screw the appliance into place.
7.
For handleless kitchens with vertical bar handle
8.
strips:
Attach a suitable filling piece
‒
any sharp edges and to guarantee a safe install-
ation.
Pre-drill aluminium profiles to establish a screw
‒
connection
.
Secure the appliance using a suitable screw
‒
24.7 Removing the appliance
Disconnect the appliance from the power supply.
1.
Undo the fastening screws.
2.
Lift the appliance slightly and pull it out completely.
3.
in order to cover
.
Advertisement
Table of Contents
