Table of Contents
Advertisement
en Troubleshooting
Fault
The time does not ap-
pear in the display
when the appliance is
switched off.
lights up in the dis-
play and no settings
can be made on the
appliance.
flashes in the dis-
play and the appli-
ance will not start.
appears in the
display.
A message with
appears in the dis-
play, e.g. - .
20.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
34
Cause and troubleshooting
The basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 19
Childproof lock is activated.
Use the
button to deactivate the childproof lock.
▶
→ "Childproof lock", Page 18
The cooking compartment is too hot for the selected operation.
Switch off the appliance and allow it to cool down.
1.
Restart the operation.
2.
The maximum cooking time has been reached. To prevent an unwanted permanent opera-
tion, the appliance automatically stops heating after several hours if the settings are un-
changed.
Switch off the appliance.
▶
You can configure new settings if required.
Tip: To prevent the appliance from switching off when you do not want it to, e.g. for an
extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 13
Electronics fault
Press the
button.
1.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. Quote the exact error
2.
message and the E no. of your appliance.
→ "Customer Service", Page 35
Place a tea towel in the cooking compartment to
1.
prevent damage.
2.
Turn the glass cover anti-clockwise to remove it .
Pull out the halogen bulb without turning it .
3.
Insert the new halogen lamp and press it firmly into
4.
the socket.
Make sure the pins are positioned correctly.
Depending on the appliance model, the glass cover
5.
may have a sealing ring. Put the sealing ring in posi-
tion.
Screw the glass cover on.
6.
Take the tea towel out of the cooking compartment.
7.
Connect the appliance to the power supply.
8.
Advertisement
Table of Contents
