Wallbox COMMANDER 2 Service Manual page 10

CPU Placement
The CPU is attached to the Control board of the Commander 2 charger.
WARNING: Never swap CPUs between Covers. It may result in
erratic behaviour of the charger and potential risks for the users.
Removing the CPU
The Control board of the Commander 2 charger is enclosed within the front cover of the charger.
1.
Turn off the power supply to the charger.
3.
Gently push outwards the two metal levers
on both sides of the CPU with your index
fingers to unclip the CPU.
10
2.
Open the front cover of the charger by
performing the steps mentioned in the
Removing the old Front cover section above.
4.
The CPU in the unclipped position forms 45º
acute angle with the Control board.