Table of Contents
Advertisement
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger seats
may be equipped with power lumbar. The power lumbar
switch is located on the outboard side of the power
seat. Push the switch forward to increase the lumbar
support. Push the switch rearward to decrease the lum-
bar support. Pushing upward or downward on the
switch will raise and lower the position of the support.
Power Lumbar Switch
FRONT HEATED SEATS —
IF EQUIPPED
WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, alcohol use,
exhaustion or other physical condition must exer-
cise care when using the seat heater. It may cause
burns even at low temperatures, especially if used
for long periods of time.
•
Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cush-
ion. This may cause the seat heater to overheat.
Sitting in a seat that has been overheated could
cause serious burns due to the increased surface
temperature of the seat.
The front heated seats control buttons are
located within the Uconnect system. You can
gain access to the control buttons through
the climate or controls screen.
•
Press the heated seat button once to turn the HI
setting on.
•
Press the heated seat button a second time to turn
the MED setting on.
•
Press the heated seat button a third time to turn the
LO setting on.
•
Press the heated seat button a fourth time to turn
the heating elements off.
If the HI level setting is selected, the system will auto-
matically switch to a lower level after approximately
15 minutes (depending on environmental conditions) of
continuous operation. The heated seat feature will then
turn off automatically approximately 45 minutes after
switching to a lower level.
NOTE:
The engine must be running for the heated seats to
operate.
For information on use with the Remote Start system,
see
page 38.
(Continued)
WARNING!
GETTING TO KNOW YOUR VEHICLE
FRONT VENTILATED SEATS —
IF EQUIPPED
Located in the seat cushion and seat back
are fans that draw the air from the passen-
ger compartment and move air through fine
perforations in the seat cover to help keep
the driver and front passenger cooler in higher ambient
temperatures. The fans operate at three speeds: HI,
MED, and LO.
The front ventilated seats control buttons are located
within the Uconnect system. You can gain access to the
control buttons through the climate screen or the con-
trols screen.
•
Press the ventilated seat button once to choose HI.
•
Press the ventilated seat button a second time to
choose MED.
•
Press the ventilated seat button a third time to
choose LO.
•
Press the ventilated seat button a fourth time to
turn the ventilated seat off.
NOTE:
The engine must be running for the ventilated seats to
operate.
For information on use with the Remote Start system,
see
page 38.
47
2
Advertisement
Table of Contents
