Table of Contents
Advertisement
128
STARTING AND OPERATING
•
During parking maneuvers, pay attention to vehicles
approaching from the opposite direction. Always
abide by the law and road regulations.
NOTE:
•
Correct system operation is not guaranteed if snow
chains or the compact spare tire are fitted.
•
The function only informs the driver about the last
appropriate parking place (parallel or perpendicular)
detected by the parking sensors.
•
Some messages displayed are accompanied by
audible warnings.
LANESENSE — IF EQUIPPED
LANESENSE OPERATION
The LaneSense system is operational at speeds above
37 mph (60 km/h) and below 112 mph (180 km/h).
The LaneSense system uses a forward facing camera to
detect lane markings and measure vehicle position
within the lane boundaries.
When both lane markings are detected and the driver
unintentionally drifts out of the lane (no turn signal
applied), the LaneSense system provides a haptic
warning in the form of torque applied to the steering
wheel to prompt the driver to remain within the lane
boundaries. If the driver continues to unintentionally
drift out of the lane, the LaneSense system provides a
visual warning through the instrument cluster display to
prompt the driver to remain within the lane boundaries.
The driver may manually override the haptic warning by
applying torque to the steering wheel at any time.
When only a single lane marking is detected and the
driver unintentionally drifts across the lane marking (no
turn signal applied), the LaneSense system provides a
visual warning through the instrument cluster display to
prompt the driver to remain within the lane. When only
a single lane marking is detected, a haptic (torque)
warning will not be provided.
NOTE:
When operating conditions have been met, the Lane-
Sense system will monitor if the driver's hands are on
the steering wheel and provides an audible warning to
the driver when the driver's hands are not detected on
the steering wheel. The system will cancel if the driver
does not return their hands to the wheel.
TURNING LANESENSE ON OR OFF
The LaneSense on/off button is located on the on the end
of the multifunction lever, to the left of the steering wheel.
LaneSense On/Off Button
To turn the LaneSense system on, push the LaneSense
button.
The white LaneSense telltale is shown in the instrument
cluster display with gray lane lines when the system is
first turned on until lane markings are detected.
To turn the LaneSense system off, push the LaneSense
button again. A "LaneSense OFF" message will be
shown in the instrument cluster display.
NOTE:
The LaneSense system will retain the last system state
on or off from the last ignition cycle when the ignition is
changed to the ON/RUN position.
LANESENSE WARNING MESSAGE
The LaneSense system will indicate the current lane
drift condition through the instrument cluster display.
When the LaneSense system is on, both lane lines are
gray when both of the lane boundaries have not been
detected. The LaneSense telltale will be white.
System On (Gray Lane Lines)
Advertisement
Table of Contents
