Table of Contents
Advertisement
204
IN CASE OF EMERGENCY
14. If the pressure is less than 26 psi (1.8 bar), DO
NOT drive the vehicle, and see an authorized
dealer.
15. If a pressure value of at least 26 psi (1.8 bar) is
detected, restore the correct pressure (with engine
running and Electric Park Brake applied), and drive
immediately with great care to an authorized dealer.
WARNING!
The Tire Service Kit is not a permanent flat tire repair.
Have the tire inspected and repaired or replaced after
using the Tire Service Kit. Do not exceed 50 mph
(80 km/h) until the tire is repaired or replaced. Fail-
ure to follow this warning can result in injuries that
are serious or fatal to you, your passengers, and oth-
ers around you. Have the tire checked as soon as
possible at an authorized dealer.
16. Apply the adhesive label from the sealant bottle
where it can be easily seen by the driver as a
reminder that the tire has been treated with a Tire
Inflator Kit, as well as not to exceed the speed
restriction for the treated tire.
WARNING!
Do not adhere the speed restriction sticker to the
padded area on the steering wheel. Adhering the
speed restriction sticker to the padded area on the
steering wheel is dangerous because the air bag may
not operate (deploy) normally resulting in serious
injury. In addition, do not adhere the sticker to areas
where warning lights or the speedometer cannot be
viewed.
CHECKING AND RESTORING TIRE
PRESSURE
The compressor can also be used to check and, if nec-
essary, restore the tire pressure.
Proceed as follows:
1. Plug the power cord in the vehicle's power outlet.
2. Release the quick connector and connect it directly
to the valve of the tire to be inflated.
3. Push the air release button.
Air Compressor Components
6 — Air Release Button
7 — Quick Connector
8 — Power Cord
9 — Release Button
SEALANT CARTRIDGE REPLACEMENT
The sealant liquid is subject to expiration and must be
replaced periodically.
•
Use only original cartridges, which can be pur-
chased at an authorized dealer.
•
Show the cartridge and label to the staff who will
have to handle the tire treated with the kit.
•
The sealant is effective with external temperatures
of between -40°F (-40°C) and 122°F (50°C). The
sealant has an expiration date.
To replace the sealant cartridge, proceed as follows:
1. Remove the sealant cartridge by pushing the
release button located on the side of the
compressor.
2. Insert the new sealant cartridge by pushing down-
ward firmly.
Sealant Cartridge Replacement
2 — Sealant Cartridge
9 — Release Button
Advertisement
Table of Contents
