KI Trek TT-Base Folding Table Assembly Instructions

leg
leveling
glide
Figure 1
short-fold
adapter plate
leveling
glide
standard
TT-base
Figure 2
Assembly Instructions
TT-Base Folding Table
Trek™, Datalink Multipurpose, Barron
®
#14 x 1"
wood screw
TT-base
vertical leg
wireway
#14 x 1"
short-fold
screw
TT-base
table top
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
& Portico™
®
July 2013
Note: The instructions below

Tools Required

illustrate the assembly of both the
• Phillips Screwdriver
lightweight folding base (Figure 1)
and the short fold base (Figure 2).

Hardware Included

The item that is required to make
• (8) #14 x 1" Wood Screws
the base a short-fold base is the
• (4) Glides
short-fold adapter plate (Figure 2).
It is only on one base of each pair. Note: The instructions below
illustrate the assembly of both the
The adaptor plate allows the folded
folding TT-base (Figure 1) and the
leg to be clamped shut while
short-fold TT-base (Figure 2).
overlapping the opposite leg.
The item that is required to make
the base a short-fold base is the
1. Place the table top upside down
short-fold adapter plate (Figure 2).
onto a soft protective surface.
It is only on one base of each pair.
The adapter plate allows the folded
2. Locate the four pre-drilled holes
leg to be clamped shut while
at each end of the table. Align the overlapping the opposite leg.
holes of each TT-base with the pre-
1. Place the table top upside down
drilled holes in the table. The folded
onto a soft protective surface
legs of the bases must be
(Figure 1).
positioned toward the center of the
table. If installation requires a
2. Locate the four pre-drilled holes
short-fold TT-base (Figure 2),
at each end of the table. Align
short-fold leg must be positioned
the holes of each base with the
over the standard leg.
pre-drilled holes in the table.
The folded legs of the bases must
be positioned toward the center of
3. Secure the bases to the table
the table (Figure 1). If installation
with four #14 x 1" wood screws
requires a short-fold base
provided.
(Figure 2), the short-fold leg must
be positioned over the standard leg.
4. Screw two leveling glides into
the threads at the bottom of each
3. Secure the bases to the table
leg.
with four #14 x 1" wood screws
provided, not to exceed 60 in/lbs of
torque (Figures 1 & 2).
4. Screw two leveling glides into the
threads at the bottom of each leg
(Figures 1 & 2).
the