Pro-Form PETL38817.0 User Manual page 8

3. Attach the Left and Right Handrails (71, 72) to
the Uprights (76) with four M10 x 45mm Screws
(2); start all four Screws, and then tighten
them.
4. With the help of a second person, hold the con-
sole assembly (A) near the Uprights (76).
Insert the Upright Wire (78) and the Ground Wire
(95) through the looped tie (B) on the back of the
console assembly (A).
See the inset drawing. Connect the Upright
Wire (78) to the console wire (C), and connect
the Ground Wire (95) to the console ground wire
(D). The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER.
5. Attach the console assembly (A) to the Uprights
(76) and to the Left and Right Handrails (71, 72)
with four M4.2 x 19mm Screws (3); start all four
Screws, and then tighten them. Be careful not
to pinch the wires.
Next, insert the connectors on the wires
(C, D, 78, 95) into the console assembly (A).
Then, pull the tie (B) tight around the Upright
Wire (78), and cut off the end of the tie.
3
2
4
D
B
95
78
5
A
B
C,D
78, 95
72
3
8
71
72
2
76
A
C
C
76
78
76
3
71