Table of Contents
Advertisement
RS2010 EN rev.1
9/2/02
Getting Started
EN
Unpacking the system:
You should have the following:
• one main unit (with 2 main speakers);
• one remote control;
• one user's guide;
• AM loop antenna;
• FM antenna;
• one safety leaflet;
• Owner registration card
Back View
2
3
MAIN
1
SPEAKER
R
L
LINE OUT
AUX IN
L
R
AC
1. Main Speaker Jacks
2. Line Out Connector
3. Aux In Connector
4. AM Antenna Jack
5. FM Antenna Jack
Using the Antenna
Before you use your audio system, you'll want to
make sure the FM antenna is positioned properly.
Connect the FM antenna to FM ANT jack on the back
of the unit. Uncoil it, making sure it is fully extended
(you may even want to tape it to the wall behind the
unit, if possible. The higher, the better.)
For AM reception, you need to connect the AM loop
antenna. Rotate the AM loop antenna for better
reception.
2
9:40 AM
Page 6
Connecting the Speakers
Each speaker has a black (negative) and a red
(positive) jack. When connecting the speakers, match
the red wires to the red jacks and the black wires to
the black jacks.
Antenna and Speaker Wire Connection
4
5
AM
FM
ANT
ANT
L
R
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
Push terminal tab down to
Release tab to lock wire in
insert wire.
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the Antenna and speaker wires at all connection
points.
Front View
4 inches
VOL
ON
STANDBY
IR
STANDBY
SOURCE
DISC 1
4 inches
DIM/
DISC 2
DEMO
TIMER
DISC 3
TOUCH SENSOR
Motorized panel
Side View
4 inches
2 inches
4 inches
Advertisement
Table of Contents
