TFA VISION 30.1025 - Digital Window Thermometer Operating Manual

Overview

Features

• Clear functional design
• Easy reading of the outside temperature from the inside
• Maximum and minimum values with auto reset
• Easy to fix, demountable for window cleaning
• Weather resistant

Specification

Do not dispose of empty batteries in household waste. Take them to special local collection sites.

Installation

Fix the holder with the enclosed adhesive outside at the window. Please clean the window glass before. Now you can hang up and demount the thermometer very easily.

Attention

Avoid direct sunshine: It falsifies the indicated values! Extremely high temperatures may lead to damages of the display. Permanent sunshine may bleach the liquid crystals.
To improve UV and rain protection and the clearness of the display especially when it's dark you find enclosed a plastic plate. We recommend the use particularly when your Vision window thermometer is located at the weather side or exposed to strong solar radiation. Simply put the plate in the provided slots behind the display.
Attention! The display is delicate! Do not pull or bend when removing the plate or demounting the thermometer.

Use

Remove the holder. Open the battery compartment by a screw driver and insert the battery. Pull off the protection foil of the display. The unit is now ready to use.
The upper display shows the maximum temperature, the middle display the current temperature and the lower display the minimum temperature.
Important note for the use: Due to the heat emission (depending on isolation) and the protected location of your window it is possible that the temperature displayed on your Vision is higher than the outdoor temperature at a free unsheltered location directly over the ground.

MAX/MIN temperatures

• There is an automatic update of maximum temperature at 8:00 and minimum temperature at 20:00. Therefore the current time must be set.

Setting of time

• Press the MODE button to enter setting mode. Set the hours by pressing the "+" button. Hold and press the button for a fast count.
• Press the MODE button again to set minutes in the same way.
• To go back to normal mode press the MODE button once more.

Maintenance

• Replace the battery when the display becomes weak.
• Do not expose the instrument to extreme temperatures, vibration or shock
• Clean it with a soft damp cloth. Do not use solvents or scouring agents.
• Please do not try to repair the unit. Contact the original point of purchase. Please change the battery before complaining. No guarantee if the instrument is handled or opened improperly.