Advertisement
PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
risk. The word ATTENTION preceded by the symbol
instrument or connected equipment.
The warranty shall become null and void in the event of improper use or tampering with the module or devices
supplied by the manufacturer as necessary for its correct operation, and if the instructions contained in this manu-
al are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available using the QR-CODE shown on page 1.
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to electro-
static discharges. Take appropriate measures during any operation.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling). The
symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to
recycle electrical and electronic waste.
DOCUMENTATION
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00598-0-EN
INSTALLATION MANUAL
Z-SG3
ZE-SG3
Z-SG3
supporto@seneca.it
INSTALLATION MANUAL
indicates conditions or actions that put the user's safety at
indicates conditions or actions that could damage the
Product information
ZE-SG3
DOCUMENTATION
commerciale@seneca.it
1/4
Advertisement
Table of Contents
Related Manuals for Seneca Z-SG3
Summary of Contents for Seneca Z-SG3
- Page 1 Z-SG3 ZE-SG3 DOCUMENTATION DOCUMENTATION SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support supporto@seneca.it Product information commerciale@seneca.it This document is the property of SENECA srl.
- Page 2 CONNECTIONS Removable 3-way screw terminals, 5 mm pitch; Rear connector IDC10 for DIN 46277 bar Serial communication ports RS485 (on terminal and IDC10), 2400 - 115200 Baud COMMUNICATION front micro USB (only Z-SG3), Ethernet port 10/100 Mbit/s (only ZE-SG3). MI00598-0-EN INSTALLATION MANUAL...
- Page 3 Input impedance: > 1MΩ; Full scale: ± 30mV ÷ ± 460mV ANALOGUE Error: 0.01% of the electrical full scale in “factory calibration” mode * INPUT Thermal stability: 0.0010%/C° of full scale. CHARACTERISTICS Cell supply voltage: 5 Vdc (supplied by the device) Resolution: ADC 24bit Response time with activated filter: 2 ÷...
- Page 4 USB PORT (ONLY Z-SG3) The module is designed to exchange data according to the modes defined by the MODBUS protocol. It has a micro USB connector and can be configured using applications and/or software programs. The USB serial port uses the following communication parameters: 38400 BAUD, 8BIT, NO PARITY, 1 STOP BIT, ModBUS ADDRESS 1.
Need help?
Do you have a question about the Z-SG3 and is the answer not in the manual?
Questions and answers