Samsung VP-D455 Service Manual page 119

ENGLISH
USB Interface (VP-D453(i)/D454(i)/D455(i) only)
Transferring a Digital Image through a USB Connection
✤
The camcorder supports both USB 1.1 and 2.0 standards. (Depends on the PC specification)
✤
You can easily transfer recorded files from a Memory Card to a PC without additional add-on cards via a USB connection.
✤
If you transfer data to a PC, you need to install the software (DV Driver, Video Codec, DirectX 9.0) supplied with the Camcorder.
USB Connection speed
High speed USB connection is supported by Microsoft (Windows) device drivers only.
Windows 98SE/ME - Full Speed USB
■
Windows 2000 - High speed USB on a system with Service Pack 4 or later installed.
■
Windows XP - High speed USB on a system with Service Pack 1 or later installed.
■
System Requirements
CPU
OS(Operating System)
Memory
HDD capacity
Resolution
USB
It is not available for Macintosh systems.
■
[ Notes ]
USB 2.0 works only for removable disk functions.
■
On a slower PC than recommended, movie playback may not be smooth or video editing may take a long time.
■
On a slower PC than recommended, movie playback may skip frames or operate unexpectedly.
■
Intel ® Pentium III™ or Pentium 4™ is a trademark of the Intel Corporation.
■
Windows ® is a registered trademark of the Microsoft
■
All other brands and names are property of their respective owners.
■
Operations are not guaranteed for all of the recommended computer environments mentioned above.
■
Do not connect the Camcorder to a PC using both DV and USB cables. It may not operate properly.
■
In CAMERA mode, be sure that the Memory card is inserted into Camcorder before connecting USB cable.
■
If no Memory card or an unformatted Memory card is inserted, PC will not recognize your camera as a removable disk.
USB Streaming requires Video Codec, DV Driver and DirectX 9.0.
■
If you disconnect the USB cable from the PC or the Camcorder during the data transfer, the data transfer will stop and the data may be damaged.
■
If you connect the USB cable to a PC using a USB HUB or with other devices at the same time, it
■
If this occurs, remove all other USB devices and try the connection again
80 80
IEEE1394 Data Transfer
System Requirements
■ CPU: faster Intel ®
■ Operating system: Windows
■ Main memory: more than 64 MB RAM
IEEE1394 add-on card or built in IEEE1394 card
■
Recording with a DV Connection Cable (VP-D451i/D453i/D454i/D455i only)
1. Set the Power switch to PLAYER.
2. Set the Mode switch to TAPE. (VP-D453i/D454i/D455i only)
3. Connect the DV cable (not supplied) from the DV jack of the Camcorder
to the DV jack of the other DV device.
■ Make sure that
4. Press the Start/Stop button to begin REC PAUSE mode.
■ PAUSE is displayed on the LCD screen.
5. Start playback on the other DV device while you monitor the picture.
6. Press the Start/Stop button to start recording.
If you want to pause recording momentarily, press the Start/Stop button again.
7. To stop recording, press the
[ Notes ]
■ When using this Camcorder as a recorder, the pictures that appear on
pictures will not be affected.
■ Operation is not guaranteed for all the recommended computer environments mentioned above.
■
While transmitting data from the Camcorder to PC at strong electric field and strong magnetic field, VIDEO signal or AUDIO signal
may transmit with noise.
Samsung Electronics
depends on the System
Windows System
Minimum
Intel ® Pentium III™, 600MHz
®
Windows 98SE/ME
128MB
1GB or more
1024 x 768 dots
24bit Colour
USB 1.1
® Corporation.
Pentium III™ 450MHz compatible.
® 98SE, ME, XP, Mac OS (9.1~10.2)
is displayed.
(STOP) button.
Recommended
Intel ® Pentium 4™ , 2GHz
®
Windows 2000/XP
512MB
2GB or more
1024 x 768 dots
24bit Colour
USB 2.0 High Speed
.
an external monitor may seem distorted, however recorded
Operating Instructions
may cause conflict and may not work properly.
ENGLISH
DV
USB
AV/ S
79 79
11-5