Table of Contents
Advertisement
•
The only devices which may be connected to the PC are those which meet
the requirements set out in the EN60950 standard "Information Technology
Equipment – Safety" or the EN60065 standard "Audio, video and similar
electronic apparatus – Safety requirements".
•
Connect peripheral devices, such as keyboards, mouse and monitor etc., only
when the PC is switched off to avoid damage to the PC or the devices.
Some devices may also be connected while the PC is running. This is often the
case for USB devices. In all cases, ensure that the information provided in the
relevant operating instructions is observed.
•
When connecting your periphery devices, also ensure that you only use the
connection cables supplied with those devices.
•
Do not expose plug connections to impacts/pressure, e.g. from lateral forces.
This could cause internal and external damage to the device.
•
When you disconnect a cable from your device, pull it out by holding the plug
and not the cable.
•
Do not exchange the supplied cable for another one. Use only the supplied
cable as this cable has been extensively tested in our laboratory.
•
Take care to ensure that all connection cables are connected to their
corresponding periphery device. Remove unnecessary cables to avoid
interference radiation.
•
Pull out the mains plug during thunder storms and remove the network cable
and aerial cable (if present) in particular. For additional safety, we recommend
using a surge protection device to protect the PC against damage due to voltage
spikes or lightening strike from the power supply.
4.2. Connecting the monitor
Your PC features a VGA*-, DVI* connection, DisplayPort* and/or a HDMI* port.
Additional monitors may also be connected, depending on the connections
available.
NOTICE!
Risk of damage!
If your monitor has multiple inputs, only ever connect
one data cable at a time to prevent signal mapping
problems.
Take care to ensure that the plugs and sockets fit
together precisely in order to avoid any damage to
the contacts. Due to its asymmetrical form, the plug
will only fit into the socket in one position.
19
Advertisement
Table of Contents
