End Cap; Wear Strip - Arctic Cat Sno Pro 120 2013 Service Manual

4. Remove the support stand; then tip the snowmobile
onto one side using a piece of cardboard to protect
against scratching. Remove the skid frame assembly.

End Cap

 NOTE: The skid frame does not have to be removed
for this procedure.
REMOVING
1. Remove the lock nut, washers, and cap screw
securing the end cap.
2. Using a hammer, tap the end cap off the rail.
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Inspect the end cap area of the slide rail for cracks
and wear.
2. Inspect the end cap for any signs of cracking or
wear.
3. Clean both the slide rail area and the end cap. Using
compressed air, clean the areas of dirt and gravel.
! WARNING
Always wear safety glasses when using compressed
air.
4. Inspect the cap screw for cracked, stretched, or dam-
aged threads. Use a new lock nut when assembling.
44
INSTALLING
1. Position the end cap on the slide rail; then align the
hole in the end cap with the hole in the slide rail.
2. Secure with a cap screws, washers, and new lock
nut. Tighten to 78 in.-lb.
 NOTE: The skid frame should be removed for this pro-
cedure.
IO115B
REMOVING
 NOTE: Prior to removing the wear strips, inspect each
wear strip for wear. The wear strip must be 0.42" thick
or thicker. If the wear strip measurement is less than
specified, replacement of both wear strips is necessary.
 NOTE: A wear strip can be removed and installed
without removing the skid frame. To do this, remove the
machine screw and lock nut securing the wear strip at
the front of the slide rail; then align the wear strip with
openings (windows) in the track and drive it rearward
off the slide rail. Apply an all-temperature grease to the
new wear strip and slide rail; then align the wear strip
with openings (windows) in the track and drive it for-
AG297D
ward onto the slide rail. Secure with the machine screw
and lock nut.
1. Remove the machine screw and lock nut securing
the wear strip to the front of the slide rail.

Wear Strip

0743-189
AG298D