Arctic Cat Sno Pro 120 2013 Service Manual page 13

12. Remove the lock nuts and rocker arm pivots secur-
ing the rocker arms to the cylinder head.
13. Remove the push rods; then remove the push rod
guide plate.
14. Remove the cap screws securing the head to the
cylinder; then remove the head and account for a
gasket and the location of the two dowel pins.
15. Remove the nut securing the flywheel to the
crankshaft and starter pulley.
10
IO071
16. Using a flywheel puller, remove the flywheel.
17. Remove the cap screws securing the stator to the
crankcase; then route the stator harness out
through the slot in the crankcase and remove the
IO072A
stator.
18. Remove the cap screws securing the crankcase
side cover to the crankcase. Account for dowel
IO073
pins, gasket, and a crankshaft shim.
IO069B
IO074
IO075A